Four typical diketopyrrolopyrrole (DPP)-based conjugated polymers were used as electron donors in all-polymer solar cells (PSCs) with a naphthalenediimide-based polymer N2200 as the electron acceptor. The four DPP polymers have near-infrared absorption spectra up to 1000 nm and suitable energy levels for charge separation from donor to acceptor. DPP polymer : N2200 cells were found to have high open circuit voltages in comparison to fullerene-based solar cells but with low short circuit current densities and fill factors, so that the power conversion efficiencies of these cells were relatively low (0.45-1.7%). These blends relatively had balanced but low hole and electron mobilities from space charge limit current measurements, small surface roughness, and highly quenched photoluminescence (PL) from steady-state PL. These studies show that the low photocurrent and performance arise from the miscibility of the DPP and N2200 polymers, which enhances the charge recombination. The finding was further confirmed by grazing incidence X-ray diffraction and resonant soft X-ray scattering. All the PSCs based on DPP polymers were investigated, opening further studies based on these systems due to the broad absorption, high carrier mobilities and good crystalline properties of DPP polymers.
1.Chinese Acad Sci, Beijing Natl Lab Mol Sci, Inst Chem, CAS Key Lab Organ Solids, Beijing 10090, Peoples R China 2.Soochow Univ, Coll Chem Chem Engn & Mat Sci, Lab Adv Optoelect Mat, Suzhou 215123, Jiangsu, Peoples R China 3.Univ Calif Berkeley, Lawrence Berkeley Natl Lab, Div Mat Sci, Berkeley, CA 94720 USA 4.Univ Massachusetts, Dept Polymer Sci & Engn, Amherst, MA 01003 USA